Δημοσιεύτηκε: 15 Ιουν 2010, 17:04
Έχω και εγώ πρόβλημα με τους αισθητήρες στο pc της υπογραφής μου. Τρέχω κανονικά το sudo sensors-detect, πατώ yes σε κάθε ερώτηση, αλλά πάντα μετά που λέει "no sensors detected", είτε τρέχω sensors στην κονσόλα είτε προσθέτω το hardware sensors monitor. Tί μπορεί να κάνω λάθος? Εδώ είναι το summary της εντολής sudo sensors-detect
- Κώδικας: Επιλογή όλων
Now follows a summary of the probes I have just done.
Just press ENTER to continue:
Driver `k10temp':
* Chip `AMD Family 10h thermal sensors' (confidence: 9)
Driver `f71882fg':
* ISA bus, address 0xe80
Chip `Fintek F71889FG Super IO Sensors' (confidence: 9)
Warning: the required module k10temp is not currently installed
on your system. If it is built into the kernel then it's OK.
Otherwise, check http://www.lm-sensors.org/wiki/Devices for
driver availability.
To load everything that is needed, add this to /etc/modules:
#----cut here----
# Chip drivers
f71882fg
#----cut here----
If you have some drivers built into your kernel, the list above will
contain too many modules. Skip the appropriate ones!
Do you want to add these lines automatically to /etc/modules? (yes/NO)y
Successful!
Monitoring programs won't work until the needed modules are
loaded. You may want to run '/etc/init.d/module-init-tools start'
to load them.
Unloading i2c-dev... OK