Δημοσιεύτηκε: 03 Μάιος 2011, 20:29
από simosx
έγραψε:[ 151.024069] usb 1-3: new high speed USB device using ehci_hcd and address 4
[ 151.277766] usbcore: registered new interface driver uas
[ 151.310365] Initializing USB Mass Storage driver...
[ 151.310601] scsi8 : usb-storage 1-3:1.0
[ 151.312782] usbcore: registered new interface driver usb-storage
[ 151.312791] USB Mass Storage support registered.
[ 152.321969] scsi 8:0:0:0: Direct-Access Generic Flash Disk 8.00 PQ: 0 ANSI: 2
[ 152.329430] sd 8:0:0:0: Attached scsi generic sg3 type 0
[ 152.331465] sd 8:0:0:0: [sdb] 7886848 512-byte logical blocks: (4.03 GB/3.76 GiB)
[ 152.331950] sd 8:0:0:0: [sdb] Write Protect is off
[ 152.331959] sd 8:0:0:0: [sdb] Mode Sense: 03 00 00 00
[ 152.332825] sd 8:0:0:0: [sdb] No Caching mode page present
[ 152.332834] sd 8:0:0:0: [sdb] Assuming drive cache: write through
[ 152.335581] sd 8:0:0:0: [sdb] No Caching mode page present
[ 152.335592] sd 8:0:0:0: [sdb] Assuming drive cache: write through
[ 152.374027] sdb: unknown partition table
[ 152.376346] sd 8:0:0:0: [sdb] No Caching mode page present
[ 152.376355] sd 8:0:0:0: [sdb] Assuming drive cache: write through
[ 152.376362] sd 8:0:0:0: [sdb] Attached SCSI removable disk
[ 182.992058] usb 1-3: reset high speed USB device using ehci_hcd and address 4


dpetridi έγραψε:Bus 001 Device 005: ID 0011:7788 εδώ λείπει περιγραφή της συσκευής.

Κώδικας: Επιλογή όλων

[ 1080.212084] INFO: task fdisk:2590 blocked for more than 120 seconds.
[ 1080.212093] "echo 0 > /proc/sys/kernel/hung_task_timeout_secs" disables this message.
[ 1080.212099] fdisk D 00000000 0 2590 2589 0x00000000
[ 1080.212109] e5d1bca4 00200086 ed984e08 00000000 ec646534 e5d1bc44 eca7f42c c183a8c0
[ 1080.212121] 46b9aabd 000000d3 eca7f428 c183a8c0 c183a8c0 ee4068c0 eca7f1a0 cd520ca0
[ 1080.212133] 00000001 f8dd0f80 cd45e000 00000000 e5d1bcf4 c1507a9d 003d05bb 12b64582
[ 1080.212145] Call Trace:
[ 1080.212161] [<c1507a9d>] ? schedule+0x3ad/0x740
[ 1080.212171] [<c150846d>] schedule_timeout+0x1ed/0x260
[ 1080.212180] [<c1509c0d>] ? _raw_spin_lock+0xd/0x10
[ 1080.212190] [<c103dd77>] ? task_rq_lock+0x47/0x80
[ 1080.212198] [<c1049e93>] ? try_to_wake_up+0x223/0x3c0
[ 1080.212206] [<c1507ff0>] wait_for_common+0xa0/0x130


Αυτό που προτείνω είναι να μορφοποιήσεις το στικάκι από Windows ξανά,
και να δοκιμάσεις δεύτερη φορά.
Τι μάρκα είναι; Αναφέρει κάτι σαν U3 κάπου στο στικάκι;