Δημοσιεύτηκε: 21 Απρ 2009, 10:53
Η sudo modprobe -v stv680 μου επιστρέφει:
Ενώ η dmesg | tail -n 50
Ανοίγοντας το cheese δεν μου αναγνωρίζει την κάμερα.
- Κώδικας: Επιλογή όλων
insmod /lib/modules/2.6.27-14-generic/kernel/drivers/media/video/stv680.ko
Ενώ η dmesg | tail -n 50
- Κώδικας: Επιλογή όλων
[ 26.060502] Bluetooth: RFCOMM TTY layer initialized
[ 26.060505] Bluetooth: RFCOMM ver 1.10
[ 26.107643] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[ 26.107654] Bluetooth: BNEP filters: protocol multicast
[ 26.193805] Bridge firewalling registered
[ 26.252458] Bluetooth: SCO (Voice Link) ver 0.6
[ 26.252467] Bluetooth: SCO socket layer initialized
[ 28.567514] [drm] Initialized drm 1.1.0 20060810
[ 28.579710] pci 0000:01:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[ 28.579724] pci 0000:01:00.0: setting latency timer to 64
[ 28.580984] [drm] Initialized sis 1.3.0 20070626 on minor 0
[ 28.582594] agpgart-sis 0000:00:00.0: AGP 3.5 bridge
[ 28.582638] agpgart-sis 0000:00:00.0: putting AGP V3 device into 4x mode
[ 28.582749] pci 0000:01:00.0: putting AGP V3 device into 4x mode
[ 30.248793] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 32.391094] hda-intel: IRQ timing workaround is activated for card #0. Suggest a bigger bdl_pos_adj.
[ 33.648013] vmnet1: no IPv6 routers present
[ 33.924019] vmnet8: no IPv6 routers present
[ 40.280520] eth0: mii ext = 0000.
[ 40.296019] eth0: mii lpa = 41e1 adv = 01e1.
[ 40.296030] eth0: link on 100 Mbps Full Duplex mode.
[ 40.296351] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 40.296554] /dev/vmnet: open called by PID 4886 (vmnet-bridge)
[ 40.296580] /dev/vmnet: hub 0 does not exist, allocating memory.
[ 40.296599] /dev/vmnet: port on hub 0 successfully opened
[ 40.296632] bridge-eth0: up
[ 40.296637] bridge-eth0: attached
[ 40.512304] NET: Registered protocol family 17
[ 40.912053] eth0: mii ext = 0000.
[ 40.928185] eth0: mii lpa = 41e1 adv = 01e1.
[ 40.928195] eth0: link on 100 Mbps Full Duplex mode.
[ 50.768018] eth0: no IPv6 routers present
[ 117.150832] ppdev0: registered pardevice
[ 117.196220] ppdev0: unregistered pardevice
[ 118.285677] ppdev0: registered pardevice
[ 118.332031] ppdev0: unregistered pardevice
[ 118.343366] ppdev0: registered pardevice
[ 118.388307] ppdev0: unregistered pardevice
[ 4202.756038] usb 2-1: USB disconnect, address 2
[ 4301.003779] usbcore: registered new interface driver stv680
[ 4301.003791] stv680 [usb_stv680_init:1555]
[ 4301.003794] STV(i): usb camera driver version v0.25 registering<6>stv680: v0.25:STV0680 USB Camera Driver
[ 4394.496028] usb 2-1: new full speed USB device using ohci_hcd and address 5
[ 4394.706766] usb 2-1: configuration #1 chosen from 1 choice
[ 4394.804866] quickcam: disagrees about version of symbol video_devdata
[ 4394.804878] quickcam: Unknown symbol video_devdata
[ 4394.805642] quickcam: disagrees about version of symbol video_unregister_device
[ 4394.805646] quickcam: Unknown symbol video_unregister_device
[ 4394.805995] quickcam: disagrees about version of symbol video_register_device
[ 4394.805999] quickcam: Unknown symbol video_register_device
Ανοίγοντας το cheese δεν μου αναγνωρίζει την κάμερα.