Ubuntu-gr Forum

Devices
-----------------------
Optiarc DVD RW AD-5200A 1.01 (/dev/sr0, CD-R, CD-RW, CD-ROM, DVD-ROM, DVD-R, DVD-RW, DVD-R DL, DVD+R, DVD+RW, DVD+R DL) [DVD-ROM, DVD-R Sequential, DVD-R Dual Layer Sequential, DVD-R Dual Layer Jump, DVD-RW Restricted Overwrite, DVD-RW Sequential, DVD+RW, DVD+R, DVD+R Dual Layer, CD-ROM, CD-R, CD-RW] [SAO, TAO, RAW, SAO/R96R, RAW/R96R, Restricted Overwrite, Layer Jump] [%7]

System
-----------------------
K3b Version: 2.0.1
KDE Version: 4.5.1 (KDE 4.5.1)
QT Version: 4.7.0
Kernel: 2.6.35-25-generic

Used versions
-----------------------
cdrecord: 3.0

cdrecord
-----------------------
scsidev: '/dev/sr0'
devname: '/dev/sr0'
scsibus: -2 target: -2 lun: -2
Warning: Open by 'devname' is unintentional and not supported.
Linux sg driver version: 3.5.27
SCSI buffer size: 64512
/usr/bin/cdrecord: Warning: Cannot read drive buffer.
/usr/bin/cdrecord: Warning: The DMA speed test has been skipped.
Cdrecord-ProDVD-ProBD-Clone 3.00 (x86_64-unknown-linux-gnu) Copyright (C) 1995-2010 J�rg Schilling
TOC Type: 1 = CD-ROM
Using libscg version 'schily-0.9'.
Driveropts: 'burnfree'
atapi: 1
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Capabilities :
Vendor_info : 'Optiarc '
Identifikation : 'DVD RW AD-5200A '
Revision : '1.01'
Device seems to be: Generic mmc2 DVD-R/DVD-RW/DVD-RAM.
Current: CD-R
Profile: DVD+R/DL
Profile: DVD+R
Profile: DVD+RW
Profile: DVD-R/DL layer jump recording
Profile: DVD-R/DL sequential recording
Profile: DVD-RW sequential recording
Profile: DVD-RW restricted overwrite
Profile: DVD-R sequential recording
Profile: DVD-ROM
Profile: CD-RW
Profile: CD-R (current)
Profile: CD-ROM (current)
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R
Drive buf size : 866304 = 846 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 137 MB
Total size: 157 MB (15:35.25) = 70144 sectors
Lout start: 157 MB (15:37/19) = 70144 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 5
Disk Is not unrestricted
Disk Is not erasable
Disk sub type: Medium Type A, high Beta category (A+) (3)
ATIP start of lead in: -11634 (97:26/66)
ATIP start of lead out: 359846 (79:59/71)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 3
Manufacturer: CMC Magnetics Corporation
Capacity Blklen/Sparesz. Format-type Type
0 2048 0x00 No Media Present or Unknown Capacity
Blocks total: 359846 Blocks current: 359846 Blocks remaining: 289702
Starting to write CD/DVD/BD at speed 48 in real SAO mode for single session.
Last chance to quit, starting real write in 3 seconds.
2 seconds.
1 seconds.
0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is OFF.
Turning BURN-Free on
Performing OPC...
Sending CUE sheet...
/usr/bin/cdrecord: WARNING: Drive returns wrong startsec (0) using -150
Writing pregap for track 1 at -150
Starting new track at sector: 0
Track 01: 0 of 137 MB written./usr/bin/cdrecord: Input/output error. write_g1: scsi sendcmd: no error
CDB: 2A 00 00 00 00 00 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 04 00 00 00 00 00
Sense Key: 0x4 Hardware Error, Segment 0
Sense Code: 0x00 Qual 0x00 (no additional sense information) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.002s timeout 200s
/usr/bin/cdrecord: A write error occured.
/usr/bin/cdrecord: Please properly read the error message above.
write track data: error after 0 bytes
Writing time: 9.088s
Average write speed 186.4x.
Fixating...
Fixating time: 0.003s
/usr/bin/cdrecord: Warning: controller returns wrong size for Ricoh Vendor Page page.
/usr/bin/cdrecord: Warning: controller returns wrong page 10 for Ricoh Vendor Page page (30).
/usr/bin/cdrecord: fifo had 64 puts and 1 gets.
/usr/bin/cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%.

cdrecord command:
-----------------------
/usr/bin/cdrecord -v gracetime=2 dev=/dev/sr0 speed=48 -sao driveropts=burnfree -data -tsize=70144s -