Δημοσιεύτηκε: 25 Νοέμ 2008, 18:27
Έχω: (από το Εφαρμογές>Εργαλεία Συστήματος>Sysinfo)
Ultimate 1.9 (Release Ubuntu 8.04.1 Hardy)
kenell 2.6.24-21-generic (#1 SMP Tue Oct 21 23:43:45 UTC 2008)
αλλά με mii-diag (Αυτό έχω στο synaptic μόνο και όχι το mii-tool. To mii-tool το έβαλα από tar.gz αλλά σίγουρα θέλει ρύθμισμα όπως είπα πριν)
sudo mii-diag -v
mii-diag.c:v2.11 3/21/2005 Donald Becker (becker@scyld.com)
http://www.scyld.com/diag/index.html
Using the default interface 'eth0'.
Using the new SIOCGMIIPHY value on PHY 0 (BMCR 0x1000).
Basic mode control register 0x1000: Auto-negotiation enabled.
Basic mode status register 0x7949 ... 7949.
Link status: not established.
This transceiver is capable of 100baseTx-FD 100baseTx 10baseT-FD 10baseT.
Able to perform Auto-negotiation, negotiation not complete.
End of basic transceiver information.
libmii.c:v2.11 2/28/2005 Donald Becker (becker@scyld.com)
http://www.scyld.com/diag/index.html
MII PHY #0 transceiver registers:
1000 7949 0141 0c25 0de1 0000 0004 2801
0000 0300 0000 0000 0000 0000 0000 3000
0068 8100 8800 0000 0170 0010 0000 0000
4105 0008 000a 848f 0000 0000 0000 0000.
Basic mode control register 0x1000: Auto-negotiation enabled.
Basic mode status register 0x7949 ... 7949.
Link status: not established.
Capable of 100baseTx-FD 100baseTx 10baseT-FD 10baseT.
Able to perform Auto-negotiation, negotiation not complete.
Vendor ID is 00:50:43:--:--:--, model 2 rev. 5.
No specific information is known about this transceiver type.
I'm advertising 0de1: Flow-control 100baseTx-FD 100baseTx 10baseT-FD 10baseT
Advertising no additional info pages.
IEEE 802.3 CSMA/CD protocol.
Link partner capability is 0000:.
Negotiation did not complete.
και σκέτο mii-diag
Ultimate 1.9 (Release Ubuntu 8.04.1 Hardy)
kenell 2.6.24-21-generic (#1 SMP Tue Oct 21 23:43:45 UTC 2008)
- Κώδικας: Επιλογή όλων
$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:11:d8:0d:22:2e
inet6 addr: fe80::211:d8ff:fe0d:222e/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:17
eth1 Link encap:Ethernet HWaddr 00:14:7f:2e:f9:af
inet addr:192.168.1.64 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::214:7fff:fe2e:f9af/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:8582 errors:0 dropped:0 overruns:0 frame:0
TX packets:9699 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:5047590 (4.8 MB) TX bytes:1539101 (1.4 MB)
eth0:avahi Link encap:Ethernet HWaddr 00:11:d8:0d:22:2e
inet addr:169.254.3.87 Bcast:169.254.255.255 Mask:255.255.0.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
Interrupt:17
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1793 errors:0 dropped:0 overruns:0 frame:0
TX packets:1793 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:69427 (67.7 KB) TX bytes:69427 (67.7 KB)
- Κώδικας: Επιλογή όλων
$ sudo mii-tool -v
SIOCGMIIPHY on 'eth0' failed: Operation not supported
SIOCGMIIPHY on 'eth1' failed: Operation not supported
no MII interfaces found
αλλά με mii-diag (Αυτό έχω στο synaptic μόνο και όχι το mii-tool. To mii-tool το έβαλα από tar.gz αλλά σίγουρα θέλει ρύθμισμα όπως είπα πριν)
sudo mii-diag -v
mii-diag.c:v2.11 3/21/2005 Donald Becker (becker@scyld.com)
http://www.scyld.com/diag/index.html
Using the default interface 'eth0'.
Using the new SIOCGMIIPHY value on PHY 0 (BMCR 0x1000).
Basic mode control register 0x1000: Auto-negotiation enabled.
Basic mode status register 0x7949 ... 7949.
Link status: not established.
This transceiver is capable of 100baseTx-FD 100baseTx 10baseT-FD 10baseT.
Able to perform Auto-negotiation, negotiation not complete.
End of basic transceiver information.
libmii.c:v2.11 2/28/2005 Donald Becker (becker@scyld.com)
http://www.scyld.com/diag/index.html
MII PHY #0 transceiver registers:
1000 7949 0141 0c25 0de1 0000 0004 2801
0000 0300 0000 0000 0000 0000 0000 3000
0068 8100 8800 0000 0170 0010 0000 0000
4105 0008 000a 848f 0000 0000 0000 0000.
Basic mode control register 0x1000: Auto-negotiation enabled.
Basic mode status register 0x7949 ... 7949.
Link status: not established.
Capable of 100baseTx-FD 100baseTx 10baseT-FD 10baseT.
Able to perform Auto-negotiation, negotiation not complete.
Vendor ID is 00:50:43:--:--:--, model 2 rev. 5.
No specific information is known about this transceiver type.
I'm advertising 0de1: Flow-control 100baseTx-FD 100baseTx 10baseT-FD 10baseT
Advertising no additional info pages.
IEEE 802.3 CSMA/CD protocol.
Link partner capability is 0000:.
Negotiation did not complete.
και σκέτο mii-diag
- Κώδικας: Επιλογή όλων
sudo mii-diag
Using the default interface 'eth0'.
Basic registers of MII PHY #0: 1000 7949 0141 0c25 0de1 0000 0004 2801.
Basic mode control register 0x1000: Auto-negotiation enabled.
Basic mode status register 0x7949 ... 7949.
Link status: not established.
End of basic transceiver informati