Ubuntu-gr Forum

Δεν γνωριζω αν εχει καποια σχεση,

Eκτέλεσα και την εντολή usb_modeswitch

Κώδικας: Επιλογή όλων

tester@tester-desktop:~$ usb_modeswitch

Usage: usb_modeswitch [<params>] [-c filename]

-h, --help this help
-e, --version print version information and exit
-v, --default-vendor NUM vendor ID of original mode (mandatory)
-p, --default-product NUM product ID of original mode (mandatory)
-V, --target-vendor NUM target mode vendor ID (optional)
-P, --target-product NUM target mode product ID (optional)
-C, --target-class NUM target mode device class (optional)
-b, --busnum NUM system bus number of device (for hard ID)
-g, --devnum NUM system device number (for hard ID)
-m, --message-endpoint NUM direct the message transfer there (optional)
-M, --message-content <msg> message to send (hex number as string)
-2 <msg>, -3 <msg> additional messages to send (-n recommended)
-n, --need-response read response to the message transfer (CSW)
-r, --response-endpoint NUM read response from there (optional)
-d, --detach-only detach the active driver, no further action
-H, --huawei-mode apply a special procedure
-S, --sierra-mode apply a special procedure
-O, --sony-mode apply a special procedure
-G, --gct-mode apply a special procedure
-N, --sequans-mode apply a special procedure
-A, --mobileaction-mode apply a special procedure
-T, --kobil-mode apply a special procedure
-L, --cisco-mode apply a special procedure
-B, --qisda-mode apply a special procedure
-R, --reset-usb reset the device after all other actions
-Q, --quiet don't show progress or error messages
-W, --verbose print all settings and debug output
-D, --sysmode specific result and syslog message
-s, --success <seconds> switching result check with timeout
-I, --no-inquire do not get SCSI attributes (default on)

-c, --config-file <filename> load long configuration from file

-t, --stdinput read long configuration from stdin

-f, --long-config <text> get long configuration from string

-i, --interface NUM select initial USB interface (default 0)
-u, --configuration NUM select USB configuration
-a, --altsetting NUM select alternative USB interface setting


* usb_modeswitch: handle USB devices with multiple modes
* Version 1.2.3 (C) Josua Dietze 2012
* Based on libusb0 (0.1.12 and above)

! PLEASE REPORT NEW CONFIGURATIONS !

tester@tester-desktop:~$

Ομως δεν μου εβγαλε το παρακατω..

Κώδικας: Επιλογή όλων

Found a new device in target mode or class
Mode switch succeeded. Bye.

Επισης, τρεχω την εντολη lsusb, και το αποτελεσμα ειναι το ιδιο με το αυτο που παρουσιασα στο αρχικο μου μηνυμα

..Δεν εγινε καποια αλλαγη..