Δημοσιεύτηκε: 05 Σεπ 2011, 21:50
μου βγαζει αυτο
- Κώδικας: Επιλογή όλων
smartctl 5.40 2010-07-12 r3124 [i686-pc-linux-gnu] (local build)
Copyright (C) 2002-10 by Bruce Allen, http://smartmontools.sourceforge.net
=== START OF INFORMATION SECTION ===
Model Family: Seagate Momentus 5400.5 series
Device Model: ST9160310AS
Serial Number: 5SV44Y6X
Firmware Version: 0303
User Capacity: 160,041,885,696 bytes
Device is: In smartctl database [for details use: -P show]
ATA Version is: 8
ATA Standard is: ATA-8-ACS revision 4
Local Time is: Mon Sep 5 21:49:30 2011 EEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
See vendor-specific Attribute list for marginal Attributes.
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 723) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 62) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103f) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 116 098 006 Pre-fail Always - 114960021
3 Spin_Up_Time 0x0003 099 099 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 098 098 020 Old_age Always - 2559
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 076 060 030 Pre-fail Always - 45218158
9 Power_On_Hours 0x0032 097 097 000 Old_age Always - 3321
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 098 098 020 Old_age Always - 2256
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 200
188 Command_Timeout 0x0032 100 093 000 Old_age Always - 253
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 047 041 045 Old_age Always In_the_past 53 (0 172 53 49)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 1372
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 158
193 Load_Cycle_Count 0x0032 071 071 000 Old_age Always - 59522
194 Temperature_Celsius 0x0022 053 059 000 Old_age Always - 53 (0 10 0 0)
195 Hardware_ECC_Recovered 0x001a 050 037 000 Old_age Always - 114960021
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 232 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 232 occurred at disk power-on lifetime: 1422 hours (59 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 be 7f 61 00 Error: UNC at LBA = 0x00617fbe = 6389694
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 80 b3 7f 61 e0 00 01:22:14.021 READ DMA EXT
25 00 80 33 7f 61 e0 00 01:22:14.017 READ DMA EXT
25 00 80 b3 7e 61 e0 00 01:22:14.013 READ DMA EXT
25 00 80 33 7e 61 e0 00 01:22:14.010 READ DMA EXT
25 00 80 b3 7d 61 e0 00 01:22:14.006 READ DMA EXT
Error 231 occurred at disk power-on lifetime: 1342 hours (55 days + 22 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 c3 7f 61 00 Error: UNC at LBA = 0x00617fc3 = 6389699
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 02 c3 7f 61 e0 00 00:07:15.081 READ DMA EXT
25 00 08 0f 56 10 e0 00 00:07:15.066 READ DMA EXT
35 00 08 0f 56 10 e0 00 00:07:15.058 WRITE DMA EXT
25 00 08 0f 56 10 e0 00 00:07:15.054 READ DMA EXT
25 00 01 00 00 00 e0 00 00:07:15.006 READ DMA EXT
Error 230 occurred at disk power-on lifetime: 1342 hours (55 days + 22 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 c1 7f 61 00 Error: UNC at LBA = 0x00617fc1 = 6389697
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 02 c1 7f 61 e0 00 00:07:12.667 READ DMA EXT
25 00 08 0f 56 10 e0 00 00:07:12.666 READ DMA EXT
25 00 01 00 00 00 e0 00 00:07:12.622 READ DMA EXT
35 00 08 0f 56 10 e0 00 00:07:12.622 WRITE DMA EXT
25 00 01 00 00 00 e0 00 00:07:12.615 READ DMA EXT
Error 229 occurred at disk power-on lifetime: 1342 hours (55 days + 22 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 bf 7f 61 00 Error: UNC at LBA = 0x00617fbf = 6389695
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 02 bf 7f 61 e0 00 00:07:10.242 READ DMA EXT
25 00 08 0f 56 10 e0 00 00:07:10.241 READ DMA EXT
35 00 08 0f 56 10 e0 00 00:07:10.241 WRITE DMA EXT
25 00 08 0f 56 10 e0 00 00:07:10.240 READ DMA EXT
25 00 01 00 00 00 e0 00 00:07:10.239 READ DMA EXT
Error 228 occurred at disk power-on lifetime: 1342 hours (55 days + 22 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 be 7f 61 00 Error: UNC at LBA = 0x00617fbe = 6389694
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 02 bd 7f 61 e0 00 00:07:07.652 READ DMA EXT
25 00 02 0b 56 10 e0 00 00:07:07.651 READ DMA EXT
35 00 02 0b 56 10 e0 00 00:07:07.651 WRITE DMA EXT
25 00 02 bb 7f 61 e0 00 00:07:07.650 READ DMA EXT
25 00 02 09 56 10 e0 00 00:07:07.650 READ DMA EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Aborted by host 20% 3313 -
# 2 Short offline Interrupted (host reset) 00% 3311 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.