Δημοσιεύτηκε: 26 Ιαν 2013, 10:45
Κοιτατε λιγο και τον δικο μου δισκο; Toν ελεγξα με GSmartControl.
- Κώδικας: Επιλογή όλων
smartctl 5.43 2012-06-30 r3573 [x86_64-linux-3.5.0-22-generic] (local build)
Copyright (C) 2002-12 by Bruce Allen, http://smartmontools.sourceforge.net
=== START OF INFORMATION SECTION ===
Model Family: Seagate Barracuda 7200.11
Device Model: ST3500320AS
Serial Number: 9QMAQQYV
LU WWN Device Id: 5 000c50 010f67e20
Firmware Version: SD1A
User Capacity: 500,106,780,160 bytes [500 GB]
Sector Size: 512 bytes logical/physical
Device is: In smartctl database [for details use: -P show]
ATA Version is: 8
ATA Standard is: ATA-8-ACS revision 4
Local Time is: Sat Jan 26 09:14:22 2013 EET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
See vendor-specific Attribute list for marginal Attributes.
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 41) The self-test routine was interrupted
by the host with a hard or soft reset.
Total time to complete Offline
data collection: ( 625) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 112) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103b) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 117 089 006 Pre-fail Always - 148156287
3 Spin_Up_Time 0x0003 095 094 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 096 096 020 Old_age Always - 4526
5 Reallocated_Sector_Ct 0x0033 082 082 036 Pre-fail Always - 370
7 Seek_Error_Rate 0x000f 078 060 030 Pre-fail Always - 21866118138
9 Power_On_Hours 0x0032 086 086 000 Old_age Always - 12909
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 6
12 Power_Cycle_Count 0x0032 096 037 020 Old_age Always - 4164
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 5150
188 Command_Timeout 0x0032 100 087 000 Old_age Always - 2289254140199
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 055 041 045 Old_age Always In_the_past 45 (4 116 45 45 0)
194 Temperature_Celsius 0x0022 045 059 000 Old_age Always - 45 (0 6 0 0 0)
195 Hardware_ECC_Recovered 0x001a 036 016 000 Old_age Always - 148156287
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 5255 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 5255 occurred at disk power-on lifetime: 11634 hours (484 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
04 71 04 9d 00 32 e0
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
ec 00 00 00 00 00 a0 00 00:05:08.475 IDENTIFY DEVICE
a1 00 00 00 00 00 a0 00 00:05:08.475 IDENTIFY PACKET DEVICE
ec 00 01 01 00 00 a0 00 00:03:43.405 IDENTIFY DEVICE
00 00 00 00 00 00 00 04 00:03:42.968 NOP [Abort queued commands]
00 00 00 00 00 00 00 ff 00:03:39.552 NOP [Abort queued commands]
Error 5254 occurred at disk power-on lifetime: 11634 hours (484 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
04 71 04 9d 00 32 e0 Device Fault; Error: ABRT
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
a1 00 00 00 00 00 a0 00 00:05:08.475 IDENTIFY PACKET DEVICE
ec 00 01 01 00 00 a0 00 00:03:43.405 IDENTIFY DEVICE
00 00 00 00 00 00 00 04 00:03:42.968 NOP [Abort queued commands]
00 00 00 00 00 00 00 ff 00:03:39.552 NOP [Abort queued commands]
00 00 00 00 00 00 00 ff 00:03:39.299 NOP [Abort queued commands]
Error 5253 occurred at disk power-on lifetime: 11634 hours (484 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
04 71 04 9d 00 32 e0
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
ec 00 01 01 00 00 a0 00 00:03:43.405 IDENTIFY DEVICE
00 00 00 00 00 00 00 04 00:03:42.968 NOP [Abort queued commands]
00 00 00 00 00 00 00 ff 00:03:39.552 NOP [Abort queued commands]
00 00 00 00 00 00 00 ff 00:03:39.299 NOP [Abort queued commands]
ec 00 01 01 00 00 a0 00 00:03:04.447 IDENTIFY DEVICE
Error 5252 occurred at disk power-on lifetime: 11634 hours (484 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
04 71 04 9d 00 32 e0
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
ec 00 01 01 00 00 a0 00 00:03:04.447 IDENTIFY DEVICE
00 00 00 00 00 00 00 04 00:03:03.962 NOP [Abort queued commands]
00 00 00 00 00 00 00 ff 00:03:00.577 NOP [Abort queued commands]
00 00 00 00 00 00 00 ff 00:03:00.324 NOP [Abort queued commands]
ec 00 01 01 00 00 a0 00 00:02:22.726 IDENTIFY DEVICE
Error 5251 occurred at disk power-on lifetime: 11634 hours (484 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
04 71 04 9d 00 32 e0
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
ec 00 01 01 00 00 a0 00 00:02:22.726 IDENTIFY DEVICE
00 00 00 00 00 00 00 04 00:02:22.288 NOP [Abort queued commands]
00 00 00 00 00 00 00 ff 00:02:18.872 NOP [Abort queued commands]
00 00 00 00 00 00 00 ff 00:02:18.620 NOP [Abort queued commands]
35 00 08 00 4d 04 e0 00 00:02:12.500 WRITE DMA EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Extended offline Interrupted (host reset) 00% 12909 -
# 2 Extended offline Interrupted (host reset) 00% 12884 -
# 3 Short offline Completed without error 00% 12883 -
# 4 Short offline Completed without error 00% 12271 -
# 5 Short offline Completed without error 00% 12269 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.