Δημοσιεύτηκε: 21 Αύγ 2013, 21:43
Πως είναι γιατρέ?
- Κώδικας: Επιλογή όλων
smartctl 5.41 2011-06-09 r3365 [x86_64-linux-3.5.0-39-generic] (local build)
Copyright (C) 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net
=== START OF INFORMATION SECTION ===
Model Family: Seagate Barracuda 7200.10
Device Model: ST3160215A
Serial Number: 9RA4NTJP
Firmware Version: 3.AAD
User Capacity: 160.041.885.696 bytes [160 GB]
Sector Size: 512 bytes logical/physical
Device is: In smartctl database [for details use: -P show]
ATA Version is: 7
ATA Standard is: Exact ATA specification draft version not indicated
Local Time is: Wed Aug 21 21:36:18 2013 EEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 430) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 54) minutes.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 120 099 006 Pre-fail Always - 244010539
3 Spin_Up_Time 0x0003 097 097 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 097 097 020 Old_age Always - 4013
5 Reallocated_Sector_Ct 0x0033 097 097 036 Pre-fail Always - 125
7 Seek_Error_Rate 0x000f 087 060 030 Pre-fail Always - 583192314
9 Power_On_Hours 0x0032 086 086 000 Old_age Always - 13052
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 097 097 020 Old_age Always - 3895
187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 1725
189 High_Fly_Writes 0x003a 001 001 000 Old_age Always - 2714
190 Airflow_Temperature_Cel 0x0022 054 047 045 Old_age Always - 46 (Min/Max 34/46)
194 Temperature_Celsius 0x0022 046 053 000 Old_age Always - 46 (0 17 0 0)
195 Hardware_ECC_Recovered 0x001a 080 064 000 Old_age Always - 105987753
197 Current_Pending_Sector 0x0012 001 001 000 Old_age Always - 4294967292
198 Offline_Uncorrectable 0x0010 001 001 000 Old_age Offline - 4294967292
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
200 Multi_Zone_Error_Rate 0x0000 100 253 000 Old_age Offline - 0
202 Data_Address_Mark_Errs 0x0032 100 253 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 2079 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 2079 occurred at disk power-on lifetime: 12450 hours (518 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 3f 72 8b e0 Error: UNC at LBA = 0x008b723f = 9138751
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 40 00 72 8b e0 00 00:02:23.146 READ DMA EXT
25 00 08 f0 71 8b e0 00 00:02:23.143 READ DMA EXT
25 00 40 d8 19 89 e0 00 00:02:23.123 READ DMA EXT
35 00 08 c0 11 f0 e0 00 00:02:20.072 WRITE DMA EXT
25 00 08 38 ff 65 e0 00 00:02:20.057 READ DMA EXT
Error 2078 occurred at disk power-on lifetime: 12450 hours (518 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 3f 72 8b e0 Error: UNC at LBA = 0x008b723f = 9138751
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 48 f8 71 8b e0 00 00:02:16.926 READ DMA EXT
25 00 08 e8 71 8b e0 00 00:02:16.920 READ DMA EXT
25 00 40 08 19 89 e0 00 00:02:16.908 READ DMA EXT
25 00 40 50 5a 44 e0 00 00:02:20.072 READ DMA EXT
35 00 08 48 d4 21 e0 00 00:02:20.057 WRITE DMA EXT
Error 2077 occurred at disk power-on lifetime: 12450 hours (518 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 3f 72 8b e0 Error: UNC at LBA = 0x008b723f = 9138751
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 50 f0 71 8b e0 00 00:02:16.926 READ DMA EXT
25 00 08 e0 71 8b e0 00 00:02:16.920 READ DMA EXT
25 00 40 f0 1a 89 e0 00 00:02:16.908 READ DMA EXT
35 00 08 b8 50 ee e0 00 00:02:16.908 WRITE DMA EXT
35 00 00 00 8d 20 e0 00 00:02:16.902 WRITE DMA EXT
Error 2076 occurred at disk power-on lifetime: 12450 hours (518 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 3f 72 8b e0 Error: UNC at LBA = 0x008b723f = 9138751
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 58 e8 71 8b e0 00 00:02:13.674 READ DMA EXT
25 00 08 d8 71 8b e0 00 00:02:13.674 READ DMA EXT
25 00 40 c0 1e 89 e0 00 00:02:13.674 READ DMA EXT
35 00 08 c8 50 ee e0 00 00:02:13.663 WRITE DMA EXT
35 00 08 20 95 e9 e0 00 00:02:13.663 WRITE DMA EXT
Error 2075 occurred at disk power-on lifetime: 12450 hours (518 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 3f 72 8b e0 Error: UNC at LBA = 0x008b723f = 9138751
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 60 e0 71 8b e0 00 00:02:09.958 READ DMA EXT
25 00 08 d0 71 8b e0 00 00:02:09.943 READ DMA EXT
25 00 40 60 26 89 e0 00 00:02:09.926 READ DMA EXT
35 00 08 b8 11 f0 e0 00 00:02:09.926 WRITE DMA EXT
35 00 08 f8 91 e9 e0 00 00:02:09.926 WRITE DMA EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 13052 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.