Δημοσιεύτηκε: 26 Μαρ 2018, 17:21
από mparteli
παιδια καλησπερα εχω προβλημα με τν σκληρο δισκο για δειτε λιγο εδω κ πειτε μου υπαρχει περιπτωση να καταφερω να παρω τα αρχεια μου?
Κώδικας: Επιλογή όλων
smartctl 6.2 2013-07-26 r3841 [x86_64-linux-4.4.0-31-generic] (local build)
Copyright (C) 2002-13, Bruce Allen, Christian Franke, www.smartmontools.org

=== START OF INFORMATION SECTION ===
Model Family:     Hitachi/HGST Travelstar 5K750
Device Model:     Hitachi HTS547550A9E384
Serial Number:    J21D0052GAJSRR
LU WWN Device Id: 5 000cca 642c4caa5
Firmware Version: JE3OA60A
User Capacity:    500.107.862.016 bytes [500 GB]
Sector Sizes:     512 bytes logical, 4096 bytes physical
Rotation Rate:    5400 rpm
Device is:        In smartctl database [for details use: -P show]
ATA Version is:   ATA8-ACS T13/1699-D revision 6
SATA Version is:  SATA 2.6, 3.0 Gb/s
Local Time is:    Mon Mar 26 14:01:35 2018 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled

=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: FAILED!
Drive failure expected in less than 24 hours. SAVE ALL DATA.
See vendor-specific Attribute list for failed Attributes.

General SMART Values:
Offline data collection status:  (0x00)   Offline data collection activity
               was never started.
               Auto Offline Data Collection: Disabled.
Self-test execution status:      ( 121)   The previous self-test completed having
               the read element of the test failed.
Total time to complete Offline
data collection:       (   45) seconds.
Offline data collection
capabilities:           (0x5b) SMART execute Offline immediate.
               Auto Offline data collection on/off support.
               Suspend Offline collection upon new
               command.
               Offline surface scan supported.
               Self-test supported.
               No Conveyance Self-test supported.
               Selective Self-test supported.
SMART capabilities:            (0x0003)   Saves SMART data before entering
               power-saving mode.
               Supports SMART auto save timer.
Error logging capability:        (0x01)   Error logging supported.
               General Purpose Logging supported.
Short self-test routine
recommended polling time:     (   2) minutes.
Extended self-test routine
recommended polling time:     ( 147) minutes.
SCT capabilities:           (0x003d)   SCT Status supported.
               SCT Error Recovery Control supported.
               SCT Feature Control supported.
               SCT Data Table supported.

SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME          FLAG     VALUE WORST THRESH TYPE      UPDATED  WHEN_FAILED RAW_VALUE
  1 Raw_Read_Error_Rate     0x000b   092   092   062    Pre-fail  Always       -       1900563
  2 Throughput_Performance  0x0005   100   100   040    Pre-fail  Offline      -       0
  3 Spin_Up_Time            0x0007   208   208   033    Pre-fail  Always       -       1
  4 Start_Stop_Count        0x0012   093   093   000    Old_age   Always       -       11326
  5 Reallocated_Sector_Ct   0x0033   001   001   005    Pre-fail  Always   FAILING_NOW 0
  7 Seek_Error_Rate         0x000b   099   099   067    Pre-fail  Always       -       65536
  8 Seek_Time_Performance   0x0005   100   100   040    Pre-fail  Offline      -       0
  9 Power_On_Hours          0x0012   054   054   000    Old_age   Always       -       20301
10 Spin_Retry_Count        0x0013   100   100   060    Pre-fail  Always       -       0
12 Power_Cycle_Count       0x0032   096   096   000    Old_age   Always       -       6482
191 G-Sense_Error_Rate      0x000a   099   099   000    Old_age   Always       -       131073
192 Power-Off_Retract_Count 0x0032   100   100   000    Old_age   Always       -       171
193 Load_Cycle_Count        0x0012   097   097   000    Old_age   Always       -       34272
194 Temperature_Celsius     0x0002   214   214   000    Old_age   Always       -       28 (Min/Max 7/52)
196 Reallocated_Event_Count 0x0032   097   097   000    Old_age   Always       -       284
197 Current_Pending_Sector  0x0022   001   001   000    Old_age   Always       -       31088
198 Offline_Uncorrectable   0x0008   100   100   000    Old_age   Offline      -       0
199 UDMA_CRC_Error_Count    0x000a   200   200   000    Old_age   Always       -       0
223 Load_Retry_Count        0x000a   100   100   000    Old_age   Always       -       0

SMART Error Log Version: 1
ATA Error Count: 21347 (device log contains only the most recent five errors)
   CR = Command Register [HEX]
   FR = Features Register [HEX]
   SC = Sector Count Register [HEX]
   SN = Sector Number Register [HEX]
   CL = Cylinder Low Register [HEX]
   CH = Cylinder High Register [HEX]
   DH = Device/Head Register [HEX]
   DC = Device Command Register [HEX]
   ER = Error register [HEX]
   ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.

Error 21347 occurred at disk power-on lifetime: 20301 hours (845 days + 21 hours)
  When the command that caused the error occurred, the device was active or idle.

  After command completion occurred, registers were:
  ER ST SC SN CL CH DH
  -- -- -- -- -- -- --
  40 51 08 d0 4b fb 07  Error: UNC at LBA = 0x07fb4bd0 = 133909456

  Commands leading to the command that caused the error were:
  CR FR SC SN CL CH DH DC   Powered_Up_Time  Command/Feature_Name
  -- -- -- -- -- -- -- --  ----------------  --------------------
  60 08 60 d0 4b fb 40 00      00:04:52.071  READ FPDMA QUEUED
  60 08 58 c8 4b fb 40 00      00:04:52.071  READ FPDMA QUEUED
  60 08 50 c0 4b fb 40 00      00:04:52.071  READ FPDMA QUEUED
  60 08 48 b8 4b fb 40 00      00:04:52.070  READ FPDMA QUEUED
  60 08 40 b0 4b fb 40 00      00:04:52.070  READ FPDMA QUEUED

Error 21346 occurred at disk power-on lifetime: 20301 hours (845 days + 21 hours)
  When the command that caused the error occurred, the device was active or idle.

  After command completion occurred, registers were:
  ER ST SC SN CL CH DH
  -- -- -- -- -- -- --
  40 51 50 d0 4b fb 07  Error: UNC at LBA = 0x07fb4bd0 = 133909456

  Commands leading to the command that caused the error were:
  CR FR SC SN CL CH DH DC   Powered_Up_Time  Command/Feature_Name
  -- -- -- -- -- -- -- --  ----------------  --------------------
  60 80 28 60 87 82 40 00      00:04:48.876  READ FPDMA QUEUED
  60 00 20 60 86 82 40 00      00:04:48.876  READ FPDMA QUEUED
  60 80 18 a0 4b fb 40 00      00:04:48.876  READ FPDMA QUEUED
  60 00 10 a0 4a fb 40 00      00:04:48.872  READ FPDMA QUEUED
  60 00 08 a0 49 fb 40 00      00:04:48.872  READ FPDMA QUEUED

Error 21345 occurred at disk power-on lifetime: 20301 hours (845 days + 21 hours)
  When the command that caused the error occurred, the device was active or idle.

  After command completion occurred, registers were:
  ER ST SC SN CL CH DH
  -- -- -- -- -- -- --
  40 51 08 88 cf 42 02  Error: UNC at LBA = 0x0242cf88 = 37932936

  Commands leading to the command that caused the error were:
  CR FR SC SN CL CH DH DC   Powered_Up_Time  Command/Feature_Name
  -- -- -- -- -- -- -- --  ----------------  --------------------
  60 08 70 88 cf 42 40 00      00:04:44.361  READ FPDMA QUEUED
  2f 00 01 10 00 00 e0 00      00:04:44.360  READ LOG EXT
  60 08 68 80 cf 42 40 00      00:04:41.189  READ FPDMA QUEUED
  2f 00 01 10 00 00 e0 00      00:04:41.189  READ LOG EXT
  60 08 60 78 cf 42 40 00      00:04:38.017  READ FPDMA QUEUED

Error 21344 occurred at disk power-on lifetime: 20301 hours (845 days + 21 hours)
  When the command that caused the error occurred, the device was active or idle.

  After command completion occurred, registers were:
  ER ST SC SN CL CH DH
  -- -- -- -- -- -- --
  40 51 08 80 cf 42 02  Error: UNC at LBA = 0x0242cf80 = 37932928

  Commands leading to the command that caused the error were:
  CR FR SC SN CL CH DH DC   Powered_Up_Time  Command/Feature_Name
  -- -- -- -- -- -- -- --  ----------------  --------------------
  60 08 68 80 cf 42 40 00      00:04:41.189  READ FPDMA QUEUED
  2f 00 01 10 00 00 e0 00      00:04:41.189  READ LOG EXT
  60 08 60 78 cf 42 40 00      00:04:38.017  READ FPDMA QUEUED
  2f 00 01 10 00 00 e0 00      00:04:38.017  READ LOG EXT
  60 08 58 70 cf 42 40 00      00:04:34.846  READ FPDMA QUEUED

Error 21343 occurred at disk power-on lifetime: 20301 hours (845 days + 21 hours)
  When the command that caused the error occurred, the device was active or idle.

  After command completion occurred, registers were:
  ER ST SC SN CL CH DH
  -- -- -- -- -- -- --
  40 51 08 78 cf 42 02  Error: UNC at LBA = 0x0242cf78 = 37932920

  Commands leading to the command that caused the error were:
  CR FR SC SN CL CH DH DC   Powered_Up_Time  Command/Feature_Name
  -- -- -- -- -- -- -- --  ----------------  --------------------
  60 08 60 78 cf 42 40 00      00:04:38.017  READ FPDMA QUEUED
  2f 00 01 10 00 00 e0 00      00:04:38.017  READ LOG EXT
  60 08 58 70 cf 42 40 00      00:04:34.846  READ FPDMA QUEUED
  2f 00 01 10 00 00 e0 00      00:04:34.845  READ LOG EXT
  60 08 50 68 cf 42 40 00      00:04:31.674  READ FPDMA QUEUED

SMART Self-test log structure revision number 1
Num  Test_Description    Status                  Remaining  LifeTime(hours)  LBA_of_first_error
# 1  Short offline       Completed: read failure       90%     20301         542890792
# 2  Short offline       Aborted by host               90%     20300         -

SMART Selective self-test log data structure revision number 1
SPAN  MIN_LBA  MAX_LBA  CURRENT_TEST_STATUS
    1        0        0  Not_testing
    2        0        0  Not_testing
    3        0        0  Not_testing
    4        0        0  Not_testing
    5        0        0  Not_testing
Selective self-test flags (0x0):
  After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.